CCM Jetspeed Vibe Junior Hockey Skates (2019)

Tongue
The traditional 7mm felt tongue featured on the CCM Vibe skates is the same one seen on the FT480 skate. The molded reinforcement layer down the front of the top five eyelets increases comfort and protection without sacrificing forward flexion. With molded lace-bite protection, the thick felt allows the tongue and boot to wrap nicely around your foot while still being able to provide maximum comfort. The tongue also features the bright red Jetspeed FT2 cosmetics, offering a more visually appealing hockey skate.

Liner
CCM’s TotalDri liner is comfortable and dries out quickly between ice times. Just like the FT480, the Vibe skate also has Durazone abrasion protection applied to the top two eyelets for additional durability in areas where the tongue can create the most friction with the liner.

Comfort Pad
The Smooth Contour comfort pad is the soft padding located at the top collar of the boot and is a big improvement over previous models. When cutting hard on tight radius turns, this padding will help prevent the boot from biting into your foot.

Holder
The CCM SpeedBlade XS holders were created to provide extreme speed, maximum energy transfer and allow players to easily swap out their blades. The holder features CCM’s own BladeLock technology to secure the runners in place, while also offering a simple way to change them without the use of any tools. The lock dial mechanism tightly secures the steel to the holder, which ultimately should translate into better energy transfer when skating.

Steel
SpeedBlade XS1 is a premium stainless steel that has an oxide treatment to provide a harder outside edge to the steel in order to hold an edge longer and prevent “slip-outs”. XS1 steel is 2mm taller than standard the XS model to provide tighter turns and longer sharpening life. These CCM runners are also seen on the Jetspeed FT2 skates.

Insoles
The CCM anatomical response footbed is one of CCM’s standard insoles. It provides a comfortable surface for the foot to land on, and a barrier between you and the rivets. The medium density foam insole has contoured edges to cup the heel of the foot and is ventilated to keep your feet cool and dry. To completely and surely dry the skate boot, remove the insoles from the skate after each ice time.

Heat Moldable
The Source for Sports exclusive model features symmetrical multi-density memory foams that heat mold easily and will provide customized fit and comfort.